DIY SPRAY SYSTEM STANDALONE 1 PIECE

PRODUCT INFORMATION FOLIATEC.com Spray System – The Revolutionary Vehicle Coating System! Our newly developed FOLIATEC.com Carbody Spray Film transforms your car optically simply in the blink of an eye. The high-quality FOLIATEC spray system powered by WAGNER, a world-leading producer of surface coating devices, was developed especially for the use of FOLIATEC.com Carbody spray film, so you can get started easily. FOLIATEC spray system with paint gun, compressor and 12 m special air hose easy application: fill in paint, insert plug and ready to use adjustable spray jet APPLICATION All parts of the car that can be easily removed must be dismantled. Mask all surfaces that should not be coated. Mask the rubber stamps with Easy Up Tape from FOLIATEC.com (item #79920). You should also protect the wheel casings and underside of the vehicle from spray mist. Clean and dry the surface to be sprayed, including edges, then degrease with FOLIATEC.com Body Spray Film Prefilter (item #79934). After cleaning, remove any remaining dust with a duster. Application with FOLIATEC.com Spray System: Apply FOLIATEC.com Carbody Spray Film in 4 to 5 generous coats. On horizontal surfaces (roof or hood), work at a slow pace and at level 1 or 2: set the quantity control on the spray gun handle to level IIII. On vertical surfaces, work at medium speed and level 2. If necessary, reduce the amount control on the spray gun handle. Only use in suitable workshops and garages. Reduce ventilation if working in a spray booth. Spray Gun Application: Apply FOLIATEC.com Carbody Spray Film in 4 generous coats at medium speed. Use a 2 to 2.5 mm spray nozzle with a pressure of 3 to 5 bar in a suitable spray booth. Flash for 10 minutes after each spray coating, done. Note: After 60 minutes, Carbody Spray Film is completely dry. After 24 hours, the vehicle is ready to drive again.