HARD ROCK LINER SET BLACK PAINT 2 5 L HARDENER 0 5 L

PRODUCT INFORMATION Our newly developed Hard Rock Liner adds a new dimension to car design and provides a real Wow! effect: the rough and coarse appearance is not only a real eye-catcher, but also offers tremendous protection against damage and outside influences. to spray aggressive look ? extremely robust, scratch resistant, highly chemical and temperature resistant removable - in combination with the FOLIATEC.com Hard Rock Liner base layer The set includes: 2 liters HARD ROCK LINER HARDENER HARD ROCK HARDENER 0.5 L Tip of the product: Best used in conjunction with our special Hard Rock Liner base coat so Hard Rock Liner can be easily removed. APPLICATION Disassemble all parts of the car that can be easily removed. Mask all surfaces that are not to be coated. Mask the rubber stamps with Easy Up Tape from FOLIATEC.com (Item #79920). You should also protect the wheel housings and the underside of the vehicle from spray mist. Clean and dry the surface to be sprayed, including edges, then degrease using FOLIATEC.com Carbody Spray Film Pre-Filter (Item #79934). After cleaning, remove any remaining dust with a feather duster. Preparation of the Hard Rock Liner: Shake the hardener in the Hard Rock Liner well for approx. 2 minutes. Fill the spray gun bottle, push on the cap, break the seal and screw the spray gun onto the bottle. Application of the Hard Rock Liner with the FOLIATEC.com Hard Rock Liner Gun (item no. 79935): Apply the Hard Rock Liner with a slow pace and pressure of 2.5 - 3 bar up to a coverage of approx. 50% is reached. After approximately 60 minutes, a second coat should be applied for 100% coverage. Note: After 60 minutes, Hard Rock Liner is powder dry and should be allowed to dry for approximately 24 hours at a constant temperature. For further instructions, read the APPLICATION sheet.